some models seem to jam the extruder
I recently installed the heated platform and the test print i was
using would stop extruding but the head would continue thinking it was
printing. the extruder would make noise like it was trying to extrude.
when I would stop it and go to the control panel and set the extruder
to extrude it works. so then i tried a different model and everything
worked correctly. then recently i ran a model through skeinforge and
the same thing happened. it is as if the 1.8 w/ heater build somehow
is lowering the feed rate under certain conditions because the ame
model seems to create the same issue. any ideas?
