I have some Gcode that will not allow my Y axis to go in reverse. It appears to be ok looking at it compared to other gcode and the motor goes both ways when I manually control it from the control panel.
All the other axis work and rotate fine. any ideas?
I don't have a feed speed but it reverts to max default.
Thanks,
Here is a snippet.
G20
G91
G1 X566.3537 Y-0.3106 A1372.0000
G1 X566.3481 Y-0.2837 A1376.0000
G1 X566.3424 Y-0.2569 A1380.0000
G1 X566.3367 Y-0.2300 A1384.0000
G1 X566.3311 Y-0.2032 A1387.9999
G1 X566.3254 Y-0.1763 A1392.0000
G1 X566.3197 Y-0.1494 A1395.9999
G1 X566.3141 Y-0.1226 A1400.0000
G1 X566.3084 Y-0.0957 A1403.9999
G1 X566.3027 Y-0.0688 A1408.0000
G1 X566.2971 Y-0.0420 A1411.9999
G1 X566.2914 Y-0.0151 A1416.0000
G1 X566.2857 Y0.0118 A1419.9999
G1 X566.2801 Y0.0386 A1424.0000
G1 X566.2744 Y0.0655 A1427.9999
G1 X566.2687 Y0.0924 A1432.0000
G1 X566.2631 Y0.1192 A1435.9999
G1 X566.2574 Y0.8255 A1440.0000
G1 X566.2517 Y1.0583 A1444.0000
G1 X566.2460 Y1.0901 A1448.0000
G1 X566.2404 Y0.8351 A1452.0000
