MK6+ Hot Head Assembly question
So I upgraded my Cupcake with Gen3 electronics to an MK6+ Step. In the 3mm instructions, it shows bolting resistors to the head, but the thermal block Makerbot sent has the new cartridge heater and no place to bolt resistors!
Is there an updated assembly instruction for the new heater? Does the thermistor go in the same place as the newer?
Here's the instructions I am going from: http://wiki.makerbot.com/stepstruder-mk6-assembly-3mm
Here's what I got: http://store.makerbot.com/mk6-plus-heater-upgrade-kit.html
Also, any tips on getting my cupcake to work with these nifty new bits?
