So, on my Makerbot (Gen3 w/ mk6 plus a & 3G5D) the temperature of the extruder takes forever to reach 220. It is heating but I don't know where to start to fix the issue.
3G5D Temperature
Forum
» MakerBot Forums / Talk about MakerBot
» 3G5D Temperature
3G5D Temperature
Are you using a relay board for the heaters? IF no, don't expect the extruder controller to last long. http://store.makerbot.com/relay-board-kit-v1-0.html
Step 2 what computer (operating system) are you using? PC, MAC, XP, WIN7?
What version of replicator-G?
What version of motherboard firmware?
What version of extruder firmware?
What replicator G driver did you choose?
3.1 all the way (both) With a mac OS and I'm using thingomatic w/hbp and mk6 ,replicator g 29
On ReplicatorG, the Dashboard freezes when i try to change the temperature. Then the whole program freezes. When I re-open it, it says Serial Port not connected.
well Moved my electronics around and put in my gen4 but it is still taking a while
with the gen 4 I only got to 140ÂșC
/forum/t-436056/3g5d-temperature#post-
